I have a bunch of plastic push blocks for my jointer that are going on 20 years old now and the grippy material has seen better days. It just doesn’t seem to hold anymore, which makes them more of a liability than a safety device. Add in the cold weather where they always had less tact, I need to do something.
Before I go out and buy 4 GRR-Ripit blocks at 25 bucks each, I’d like to see if I can replace the grippy material on the ones I have.
Does anybody sell just the grippy material? Ideally from the GRRiRipit blocks or similar? Anybody have any tricks for doing this? Special adhesives to use?