Need help. What tools do I need to change out and replace the spindle in the headstock of my pm 3520c.
Need help. What tools do I need to change out and replace the spindle in the headstock of my pm 3520c.
You might get more response if this was posted in the Turner's Forum. You could ask a Moderator to do that for you.
Ken
So much to learn, so little time.....
I suspect that earlier power matics have a similar bearing arrangement than your newer C model. Here are the instructions on replacing the bearings on a 3520a: https://hillcountryturners.org/Proje...matic3520A.pdf
Wasn't Powermatic tech support any help?
"Only a rich man can afford cheap tools, as he needs to buy them again and again"
I had to replace the bearings on my A model after about 5 years. Bought the bearings and a new belt from a local supply house, took it to a local tool repair shop that I had good relations with, and they fixed it for less than I could buy the parts from PM/Jet. If you take it to a repair shop, remove the motor first. Much easier to haul around....
robo hippy
This is a good site for all thing Powermatic 3520. https://MustardMonster.colvintools.com
There is a video link to changing bearings on a Jet 1642 which has similar construction.
God is great and life is good!