So I have been in need of more shop space for a while and finally decided to move some equipment into an unused office space in the front of my shop. The way my shop is shaped would make it impractical to run a line from my main 10hp dust collector. I have a Harbor Freight 2HP unit that I bought several years ago in a pinch before I got my larger dust collector. Since that dust collector is not being used I figure it would be good to use in my 23ft x 21ft office. I have an upcut saw on one 23ft wall and my miter saw station on the other. Work bench in one of the shorter walls and sanding table in the center. Line borer and pocket hole machine on the other shorter wall. My plan is to put the dust collector next to my work bench and pipe it up to the ceiling then run a Wye with a trunk line going to both side walls. My question is would it be ok to use 6” trunk lines for this?