My first go using a domino 700 and making a mitered edge table.
It’s sapele and I think paduak strip.
I’m leaning toward Arm a Seal satin for ease of application and quickness in drying. Anything else I should look into? I have a toddler and new born so time is limited.
Also, there is a small gap on both ends like the picture shows. It’s about 3/4 of a millimeter. It’s the underside of the shelf so not visible. I was wondering if I should cut a small piece of wood and slide it in there with a glue for support? Since the glue is on the top side of the shelf.
The shelf is 68 inches long and I have a sitter support on the back side. It’s also 11 1/2 inches wide.
free image upload no registration