Just wondering if anyone may have a suggestion. I make wooden nets and engrave my logo into the handle. The handles have a bit of a curve in them with 4 strips on either side. I obviously want the logo centred as precise as I can get in the handle. I currently use frog tape which is somewhat transparent but not really, to do a test burn. If the logo is centred, I remove the tape and burn it. Sometimes it may take 2-3 tries to get it where I want it and sometimes it’s hard to see if the image is centred through the tape. Is there something that is more or less clear that does show an image that you can see if it’s centred? I will usually do the test with the tape at 35 power and 100 speed. Thanks.