Anyone have ideas or suggestions for a table / mobile cart to mount a power feeder? My idea is to build it to be moved with a pallet jack, so I can easily block up the feeder to the height of whatever machine. Then clamp the cart directly to the machine. It would be built with a top at the same height as my lowest machine, the jointer. Weight it heavily at the bottom using scrap steel, iron, or sand. Mount the feeder near a corner of the top to reach over onto machines. Top would be steel, maybe 1/4". When not in use, swing the feeder over the top of the "cart" and move with the pallet jack.
It would be used at the tablesaw, bandsaw, shaper, jointer, and router table. I just ordered a CoMatic DC40 with extended arm in 110v.