Results 1 to 4 of 4

Thread: Aftermarket Chuck that fits a Trotec Rotary

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-16-2023, 11:20 PM #1
    Joe Adams's Avatar
    Joe Adams
    Joe Adams is offline [OP] Contributor
    Join Date
    Oct 2009
    Location
    Houston, Texas
    Posts
    395

    Aftermarket Chuck that fits a Trotec Rotary

    I have a Trotec Speedy 300 that has a rotary unit which will accept a 80mm or 3" Chuck.


    The spindle has a male M10-1.5 stud that is 19mm long to the shoulder.


    Trotec sells a Czeck-made TOS Svitavy 80mm 3-jaw chuck with a bolt on adapter for $$$$.


    I am looking for a more cost effective solution since I will only use this setup on rare occasions for engraving pens, etc.


    Has anyone found an aftermarket chuck and more importantly an M10-1.5 adapter that will work?


    Thanks for your help.


    Joe
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules