I will be using T-III for gluing 1/2" x 2" HM solid wood to the edge of 18mm Baltic Birch [HM centered on the BB edge - like a 32" L x 4" H x 2" flange width I-beam]
A pair of these will be runners and kickers for opposing 13" wide x 15" deep drawers in a coffee table, if that matters. 32" clear span, except for Z-clips outside the drawer run for attaching table top.
I plan on sanding to 120 - 150 to flatten BB edge. Can I expect the same adhesion as if I was gluing HM to HM?
Any special prep to the edge of the BB? Screws appropriate? Screws into cross-bore wood dowels? Or am I over-driving my headlights here - shut up and glue.