Hi, I’m new here and was hoping to get some advice. I just bought a 220 3k water cooled spindle, when it arrived it came with a 110 volt power cord, has a standard 110 volt plug. I spoke with the seller and asked if it has 110 input on the inverter and they said it’s 220 volt input. It was built in China and the rep is also in China so it’s been difficult communicating with him. The input lugs are marked L and N and there’s a ground, I’m assuming i apply a hot to the L and N and of course the ground to ground. I’m just confused as to why they would ship it with a 110 cord, the cord is also shown in the ad on Amazon, the inverter does state 220 on the label, this is the spindle I bought.
CNC Spindle Motor Kits, 220V 3KW 100mm Water Cooled Spindle Motor CNC motor +220V 3.7KW VFD+Clamp Mount +Water Pump+ Water pipe+ER20 Collet set + Drill bits+ wires+wrenches for CNC Router Machine https://a.co/d/0B5W3l3