I cleaned off the top of the bench..other then tools that get a lot of use...the rest went and hid over here...
Shop Saturday, Busy corner.JPG
Outside of the doors has become a "Ready Rack"...time to open a door, or 2?
Shop Saturday, Upper Left door.JPG
Inside the top of the Left door...just a few saws...just below here..
Shop Saturday, Lower Left door.JPG
Turn slightly to your right..just a tad..
Shop Saturday, Upper Left cabinet.JPG
Then look down...
Shop Saturday, Lower Left Cabinet.JPG
Then to the right, just a bit..still looking down..
Shop Saturday, Right side of cabinet.JPG
Then look up at the "roof" of the box...
Shop Saturday, Upper Right side.JPG
And finally the door on the right hand side of the box.
.Shop Saturday, Lower Right Door.JPG
All I ever need to do while working at the bench, is to simply turn around, open a door, and pick out the tool(s) required at the bench..
These are all "Working" tools....and they do get used....the hard part? Putting them all back into the box...
Thanks for looking in