I thought I posted this but must not have hit submit, so here we go again. I have a jewelry armoire that I am building that has six drawers. Approx 15" x 12" x 2 1/2" deep. I plan on putting partitions lines with with velvet paper on the bottom and sides of the partitions.
My plan is to cut the notches for the partitions on the router table with a 1/4" straight bit (1/2" shank) using the INCRA LS positioner. The grooves or dados will be cut from a 6" x 1" board across the grain, then I plan on taking that and cutting 1/4" strips on the table saw. I know a lot of folks use the TS for the grooves and it may be faster, but I don't have a square tooth blade (only ATB).
Does this sound a plausible way to cut these?
Ashampoo_Snap_Thursday, August 31, 2023_13h36m07s_021_.jpg Ashampoo_Snap_Thursday, August 31, 2023_17h15m17s_022_.jpg