I've been trying to find a shaper cutter that makes this simple edge in one pass.
I've looked at Roundovers, Ovolo's and various table edge profile and can't find one that seems to match.
I estimate that the board is 1" thick, and that step from the top about an 1/8", but the profile seems to run flat on the top and side for about a 1/4"-3/8".
I think I can do it in steps, with a 1/2" rounder, but if there is a cutter available, I'd rather use that.
Thank you for the help.
IMG_4833 (1).jpg