I've got a new to me MM16 bandsaw. When I got the saw, the switch wasn't working. After blowing some dust out of it, and generally fiddling with it, I got it working. However, after about 15 hours of use, the switch started malfuncting again. (The start button didn't have any tension on it, and pressed in with no effect.) For awhile, I was able to make the switch work by tapping on it, and getting it to reset, but today that stopped working.
The switch in question is an
AEG Mbs 25
I've done a little digging around and it looks like it's no longer in production.
I'm wondering if there's a way to rehabilitate the switch, or barring that, if there's a source for a replacement switch. I'm planning to call SCM Group in the morning to see if they carry a one.