Since you've said that the VCarve preview looks good, you should be looking that the machine setup for an answer. As I asked in my first reply, what post processor are you using?
Grant
Ottawa ON
George, how are you setting z-zero? If you move to a safe place not over the workpiece and type G0 Z0 in g-code where does the bit go?
Im sorry everybody I think I just figured it out. I upgraded the zaxis to onefinitys z20 heavy duty system and didnt change the settings for it. It is meant to move faster and have more torque. The unit is turning x amount of revolutions thinking its .1" but is actually traveling double.
It seams I didnt follow All of the instructions. I'm on the 1F forum but usually only log in 1 time a month or so. The amount of time I spend on SMC usually fills my downtime at work. I check activity while finishing my morning coffee and usually 2-3 times a day for 5-10 min. This is my favorite community.