these are good looking designs , found this one and i will trace it using logic trace and create a *.dxf file to cut it on the CO2 laser
https://stankern.vids.io/videos/0690...re-and-compass
these are good looking designs , found this one and i will trace it using logic trace and create a *.dxf file to cut it on the CO2 laser
https://stankern.vids.io/videos/0690...re-and-compass
Very nice Stan, I learn something about the Logic Trace software every time I watch one of your videos.
My current project is tracing a sink cutout for my new solid surface countertops in the kitchen. It's a bit of an odd shape and will be much easier and faster to cut on my CNC Router.
been there done that
Also I did one with shaper origin way back it ws tricky getting the ID tape behind the counter top but
it did work
After 2024 gets going I am going to get into fiber laser just another spot to learn something new
I ordered a 100w mopa galvo fiber laser , anxious to see how that goes, so my drawing will have to be shrunk down big time
stan
Good luck with the new fiber laser, can't wait to see how it works for you.
thanks anxious to see what can be done