I read the resaw feeder thread with interest. I have a Laguna LT-18 w/5hp, Resaw King blade and am limited by my ability to hold stock against the fence. The saw will easily resaw 16" to 1/8" veneer, but one little slip or waver, and I've got a bad piece. I've got a featherboard against the bottom but have been struggling to both push the work and hold the top evenly against the fence. Problem gets worse as plank size gets longer. If there was a resaw feeder made for the LT-18, I'd jump on it. The Comatic seems too large, but if anybody's tried it on an LT-18, I'd love to hear. Any suggestions welcome, and thanks in advance. I do have a roller infeed and outfeed setup.