DeltaX5 Table Saw Switch

[Richard Sichak]

Hello, I am new to the forum and I am having a problem with my on off switch. I have a Delta X5 3HP Cabinet saw. I bought the top half of the switch and wired it. I must have copied something wrong as the pish button on the switch doesn't have power to it to engage and hold the switch on. I can manually push the contact to activate the switch but the button doesn't do it. Attached are pictures of the wired switch. Can you see what could n
be wrong? Thank you in advance. Richard Sichak

[mike stenson]

There should be a wiring diagram inside the cover.

[Dan Barber]

Agree with Mike, look for the wiring diagram inside the machine. Also, the part you have in the pictures is called a contactor, not a switch.

[Dan Friedrichs]

Looks like terminal 3 (L2 along the top edge) is wrong. You've got it hooked to one side of the coil, but it otherwise doesn't go anywhere.

[Bill Dufour]

Single or three phase. Make sure the coil voltage is correct. Check the off switch has continuity.
Bill D

[Richard Sichak]

Single phase

[Richard Sichak]

Ok thanks on the contactor (switch) terminology. I will look for the diagram. Thank you.

[Richard Sichak]

Thanks I will look.

[Richard Sichak]

Thank you, I will look for the diagram inside the cover.