I installed our 36” Pre-Hung door, I have the hinge side nice plum and straight. Using wedges and GRK 4” screws, all looks good till I check inside. Top is square, I don’t have latch side of door screwed down yet. When I went inside to check out my work on hinge side I notice at top hinge there was no gap between frame and door. Looking at bottom hinge, there is a gap up to middle hinge which looks normal. I’m using a new 7’ Empire level to check if that side of door frame is straight and it is. Heading up tomorrow to start over but before I do, what should I look at to correct my mistake? It’s not easy answer and not easy explanation but thought I would try. Thanks for any guidance