Hi

I have a Delta Model 37-190 Jointer and am having issues with the beds being out of level wrt the fence. I am the original owner. When I set the fence to 90 degrees wrt the in-feed table, the out-feed table is no longer at 90 degrees to the fence. I've attached a few pictures of this issue. The only basic adjustment I see is the height adjustment of the out-feed table.

The pictures show a square on the in-feed table with it set to 90 degrees (no gaps) and then I put the square on the out-feed table with a gap near the bottom. I did the same experiment with my Wixey digital angle gauge and zero'd it on the in-feed table and then it shows that the out-feed table is slightly tilted.

I am not seeing a way to resolve this and wondering if anyone knows how to resolve this. Are some sort of shims needed?

thank you,

'mark


IMG_7247.jpg
IMG_7251.jpg
IMG_7248.jpg
IMG_7252.jpg
IMG_7253.jpg