Hello,
I've scoured the forum for feedback, but have not seen this addressed. I purchased a new Bosch GCM12SD miter saw. Trying to calibrate. While I adjusted the 90 degree detent, perfectly zero'd in, the 45 degree detents are off ~.5 degree. Is there a way to adjust the 45 detents without disruption the 90?
I've read the detents are plastic. Not sure if this contributes to the issue. Has anyone had and resolved this concern? I have a whole house of door and window casing to trim out. I would like to use this for, but need accurate cuts. Otherwise love the saw. (except for having no shadow line.)
Any words of wisdom or experience would be appreciated.
Thank you, thank you.