What sort of power arrangement does your shop have?
Which is the best set up as far as a load center, cut off switches, receptacles?
Does each machine have a dedicated circuit?
I am thinking about running a load center off the main panel (home type circuit) Putting at least one 240v 30 amp circuit for the cyclone DC and the rest dedicated circuits for the rest of the machines. Maybe leave two spaces for a future 3 ph cicuit in case I need on in the future.
The lighting I figure I would leave on the existing circuit as it is very minimal, 3 flourescent/2 bulb 4ft hanging lamps.
I would need shut off switches so I could disconnect each machine individually and maybe a main shut off ahead of the load center to keep everything off when I am not there, maybe have a lock on it for safety.