I am building a large Entertainment center in my garage. This will be a built in that goes in a media niche. I am using alot of Pocket joints with my new Kreg tool. I would like to assemble it in the garage with the Kreg screws, smooth everything out, then disassemble the ET so I can stain it and move it in the the house. I am wondering if I do this will I strip the holes when I try to reassemble it in the house? I am using Maple and maple ply with course Kreg screws. Or should I just cut all the pieces, Pre drill the pocket holes, stain it and then assemble once in the house and hope for the best?