Results 1 to 4 of 4

Thread: Tucker vise installed

  1. 08-06-2006, 2:44 AM #1
    David Mueller
    David Mueller is offline [OP] Member
    Join Date
    Oct 2005
    Location
    Carol Stream IL
    Posts
    106

    Tucker vise installed

    Just some pictures of my LV Tucker vise I just installed. Now on to the twin screw on the end. Enjoy.

    Img_0134.jpg Img_0135.jpg Img_0139.jpg

    OPEN WIDE!

    Img_0136.jpg

    What's in my belly?

    Img_0140.jpg
    David Mueller

    Knowledge gained is directly proportional to the amount of equipment destroyed.
    Reply With Quote Reply With Quote
  3. 08-06-2006, 3:54 AM #2
    Vaughn McMillan's Avatar
    Vaughn McMillan
    Vaughn McMillan is offline Member
    Join Date
    May 2005
    Posts
    3,008
    I dunno, David, that vise looks pretty crooked in a couple of the shots. I think it might be faulty, so you should send it to me...I'll try to fix it. May as well send that old beat-up bench with it too, and I'll try to clean it up a bit for you too.

    Looks like a great setup, and very usable. I'd really like a nice bench and vise like that someday. Maybe when I get a real shop instead of an overcrowded carpeted garage.

    - Vaughn
    Reply With Quote Reply With Quote
  4. 08-06-2006, 7:50 AM #3
    Frank Fusco's Avatar
    Frank Fusco
    Frank Fusco is offline Member
    Join Date
    Jun 2005
    Location
    Mountain Home, Arkansas
    Posts
    1,135
    Never saw that model before. Looks very versitile. Also looks expensive.
    Reply With Quote Reply With Quote
  5. 08-06-2006, 8:11 AM #4
    Bob Childress's Avatar
    Bob Childress
    Bob Childress is offline Member
    Join Date
    May 2006
    Location
    Greenville, South Carolina
    Posts
    756
    Great looking vice . .er, vise! Is that an air conditioner I see in the background? You really know how to hurt a guy.
    Cheers,
    Bob

    I measure three times and still mess it up.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. REVIEW Anant 10.5" vise
    By Brian Hale in forum General Woodworking and Power Tools
    Replies: 18
    Last Post: 04-30-2013, 6:01 PM
  2. Vises
    By Michael Gabbay in forum Neanderthal Haven
    Replies: 20
    Last Post: 11-01-2005, 7:43 PM
  3. Vise instalation and bench racking questions
    By Dan Forman in forum Neanderthal Haven
    Replies: 10
    Last Post: 09-03-2005, 11:58 AM
  4. Unisaw Resto 99% done, DeWALT sliding table installed *PICS*
    By David Eisan in forum General Woodworking and Power Tools
    Replies: 9
    Last Post: 05-29-2005, 6:09 PM
  5. Trying Out an Emmert Vise Clone
    By Bob Smalser in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 05-02-2005, 8:59 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules