Has anyone here used and installed some Blum Tandem drawer slides?
I'm planning on replacing my mothers kitchen drawers and plan to use these slides.
Any tips, concerns?
I remember see a article that show a way to make the drawers so the the drawer bottom could be replace, and you didn't have to drive the hole in the back of the drawer. The clip hooked over the drawer bottom. Does anyone remember seeing that article that could point me to it?
I'm also wondering if I should use rear or side mounts on the back end. I could use either based on the current cabinet contstrution. Is there an advantage to one or the other?
This will be a overlap drawer in a face frame cabinet.