I need to build an oufeed table for my Unisaw, but my shop space is too small for a big, stationary table. After looking at a recent thread here, I had a thought...

What if I build a relatively small, say 24" deep, fixed outfeed table, attached firmly to the back rail of my Biesemeyer fence, with braces to support the far end. Then from that, I'd hang a hollow core door from hinges, so it'd fold down when not needed. I'd attach adjustable folding legs to the hollow core door to support it when in the up position.

A hollow core door is essentially a lightweight torsion box, right? That being the case, it should stay relatively flat.

Has anyone else done something like this?