Results 1 to 2 of 2

Thread: Black Locust NE

  1. 02-28-2007, 4:51 PM #1
    Ron Erickson
    Ron Erickson is offline [OP] Member
    Join Date
    Nov 2006
    Location
    Remsen Ia.
    Posts
    172

    Black Locust NE

    The idea was from the "Woodturning Projects" book by mark baker. It was turned wet all the way, then DNA and dried. It is 3 1/2" high and 6" wide, less then 1/8" thick on the bowl. Oil and wipe on poly finish. I'm not sure I like the shape.
    Ron

    Natural edge bowl 1.jpg
    Natural edge bowl 2.jpg
    Reply With Quote Reply With Quote
  3. 02-28-2007, 9:06 PM #2
    Gary Herrmann's Avatar
    Gary Herrmann
    Gary Herrmann is offline Member
    Join Date
    Dec 2004
    Location
    St. Louis
    Posts
    3,349
    Nicely done, Ron. I especially like the foot. It flows well.

    O moderators on high, can we move this over the spinny forum?
    Where did I put that tape measure...
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Black Locust?
    By Roger Myers in forum Turner's Forum
    Replies: 5
    Last Post: 06-04-2006, 1:16 AM
  2. Black locust
    By Mac McAtee in forum General Woodworking and Power Tools
    Replies: 12
    Last Post: 10-01-2005, 1:24 PM
  3. Black Locust Burl Bowl (pics)
    By Bill Grumbine in forum General Woodworking and Power Tools
    Replies: 10
    Last Post: 08-31-2004, 3:22 PM
  4. 1st Black Locust bowl
    By John Miliunas in forum General Woodworking and Power Tools
    Replies: 33
    Last Post: 03-02-2004, 11:07 PM
  5. Black locust
    By Nathan Hoffman in forum General Woodworking and Power Tools
    Replies: 2
    Last Post: 09-24-2003, 3:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules