Results 1 to 2 of 2

Thread: splitter question

  1. 05-19-2007, 8:53 PM #1
    Aaron Kline's Avatar
    Aaron Kline
    Aaron Kline is offline [OP] Member
    Join Date
    May 2004
    Location
    Eastern PA
    Posts
    180

    splitter question

    I had a thin kerf blade on my saw and switched to a full kerf blade. I already drilled for a tk micro jig splitter in the zero clearance plate. Can I just use full kerf splitters in the same holes or not?
    Reply With Quote Reply With Quote
  3. 05-19-2007, 10:30 PM #2
    Russ Massery's Avatar
    Russ Massery
    Russ Massery is offline Member
    Join Date
    Dec 2004
    Location
    NW Indiana
    Posts
    1,050
    Nope, There a different patten all together.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Slick splitter design
    By Jamie Buxton in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 12-20-2009, 2:15 PM
  2. Delta Unisaw splitter question
    By Mark Berenbrok in forum General Woodworking and Power Tools
    Replies: 6
    Last Post: 12-14-2006, 4:43 PM
  3. MJ Splitter Issue - ANSWER from MicroJig
    By Dennis Peacock in forum General Woodworking and Power Tools
    Replies: 24
    Last Post: 07-11-2005, 6:16 PM
  4. MicroJig splitter question
    By Peter Gavin in forum General Woodworking and Power Tools
    Replies: 4
    Last Post: 03-07-2005, 6:17 PM
  5. Question on Zero Clearance plate and homemade splitter
    By Delano Mireles in forum General Woodworking and Power Tools
    Replies: 21
    Last Post: 08-20-2003, 12:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules