Double sided tape glue removal

[Jim Young]

In a project where I had two pieces taped together so I could make the parts the same, I now have tape glue on them after seperating them from the tape. How do I get the glue off? I already tried mineral spirits but it didn't work. Not sure if using kerosene will work nor if it will somehow affect the finish. The parts are made of walnut, if that matters.

[Gary Keedwell]

Ain't that a pain in the neck. (or a bit lower)? How about acetone or maybe denatured alcohol? They do have a product that remove stickers and glue. I think it is something like goo be gone?
Gary

[Dan Forman]

Naptha (lighter fluid) should work. Sometimes you can take another piece of the tape and use it to pick up the recalcitrant gunk.

Dan

[Gary Keedwell]

"racalcitrant gunk". There's always one in the crowd. If your going to use a fancy word...at least spell it right. RECALCITRANT
Gary

[Larry Conely]

Bestine, also known as rubber cement thinner. Available at art stores. I keep it on hand for a number of reasons. It cuts many types of glue, but is safe for most surfaces, including auto paint and every wood finish I can think of. Flammable, but evaporates almost instantly.

Larry

[Phil Thien]

Lacquer thinner.

[Jon Lanier]

I deal with that all the time with scrolling. You may need to use a heavy dose of thinner several times. Then, with a light touch use a orbital sander 220 grit. Repeat with thinner and sander if not all removed.

[Dan Forman]

"racalcitrant gunk". There's always one in the crowd. If your going to use a fancy word...at least spell it right. RECALCITRANT
Gary

Don't know how that "a" got in there, probably some vast right wing canspiracy! That's what I get for not proof reading.

Dan

[Keith Cope]

The readily available product is GooGone--I think it's citrus oil based and will probably not play nice with the finish. Might be worth a test on a scrap piece, though.

[Gary Keedwell]

Don't know how that "a" got in there, probably some vast right wing canspiracy! That's what I get for not proof reading.

Dan

LOL OK DILLARY
GK

[Don Hein]

Call the manufacturer of the tape for advice. Try warming the residue with a hair dryer set on low, then when the goo is soft use a freshly dressed scraper. Good luck.

[Don Hein]

Also, if gentle warming doesn't help, you might try putting the items in the freezer for a few hours; I've heard of chewing gum being removed that way.

[Curt Harms]

I just did the stick-two-pieces together and cut 'em trick. I used turners tape rather than carpet tape. The stuff ain't cheap, $15.99/roll or so but it holds VERY well in shear pretty good tensile strength but will come off the stock with no residue. I get mine at Woodcraft years ago.

http://woodcraft.com/family.aspx?familyid=390

HTH

Curt

[Jim Young]

Lots of chemicals mentioned in this thread. I'll try a scraper first, then if that doesn't work I'll go out and buy some naptha (been wanting some for the turnings anyway). Thanks for the ideas.

[Gary Keedwell]

Naptha (lighter fluid) should work. Sometimes you can take another piece of the tape and use it to pick up the recalcitrant gunk. At 10:57 at nite, too!!!

Dan

I knew you would go back and spell it right!!!
Gary