First Table Saw

[Ken Fitzgerald]

Depending on the amount of money you want to spend.....

I have the TS3650. I bought it when it first came out. It has served me well. I'd also consider looking at the Grizzley lines. A lot of folks have them and really are quite satisfied with them.

[Fred Voorhees]

If you have the opportunity to go directly to a better saw than a contractors unit, I most definitely would go that route. While my current Delta contractors saw has served me well for over ten years, I am just about ready to begin shopping for a cabinet model and look forward to the next phase of my shop....that being upgrading all of the machines.

[Bruce Wrenn]

Most woodworkers wish that their second table saw had been their first. If Sears is close to you, look at the 22124. Many sing it's praise. Despite owning four Delta contractor's saws and a Uni, I still lust for a 22124. Don't ask me why. I just think it is one nice saw. Every time I go into Sears (about three times a year), I stop and check out the 22124.

[Todd Warren]

Went out to the tool store on boxing day and found a good deal on the General, I set it up and will be trying it out this weekend.