Hello,

About 2 years ago I purchased the Craftsman Professional Router (without the light) that looks just like the Bosch 1617EVS. The router works fine with the exception of tightening the collet - but I'll save that for another thread...

My setup consists of a Benchdog Cast Iron Router Table extension on my Grizzly 1023S tablesaw. When I tried to line up the holes for the benchdog router table insert to the Craftsman fixed base, nothing lined up even remotely. My base did not even come close to the Bosch 1617EVS router holes, so I ended up spending a few hours making my own lined-up holes, which was intense to say the least.

Well, as it turns out now, I need to insert a bushing for a 1/4" spiral bit, however the Benchdog router table insert does not accommodate for any bushings. The router plate itself is too thick and the opening is too large for the bushing.

So my concern now is to find a way to get this to work. My thoughts were that I was going to need to purchase a new router table insert for this router, but I know that I'm going to have the same struggles with no holes to match my craftsman router unless I go through that mess again drilling holes and lining things up. Not to mention, the bushing kit I purchased insists that the bushing must be *exactly* centered or the kit will not work. (Fairly obvious for any bushing kit I assume)

My thoughts were this - does anyone own both of these routers in their workshop? I was thinking if the bases looked the same between the Bosch and the Craftsman router (I've only used the Craftsman, not the Bosch) would the Craftsman router fit into the Bosch fixed base? If so, I would probably purchase a Bosch fixed router base and then not have to worry about what router table insert I go with. The router itself has a number of cut-out grooves that interlock into the fixed base for the adjustment screw that changes the height. There's also a small pin that has to be lined up before the router can be inserted into the base. I can take detailed pictures of my router if that could help anyone.

So after my long winded post (sorry!), does anyone know if this will work? Does anyone have these two routers that they can test this setup before I go ahead and invest any more $$ into my router? My only other alternative is to bite the bullet and purchase the Bosch Router set, but I was hoping to use that on something else that I didn't have in my workshop....

Many Thanks to all!
S.F.