For some reason, without any explanation, my Jet 10" contractor is out of wack. It was cutting beautifully when all of a sudden, I noticed that a board I was cutting was binding. Upon checking my blade allignment, I noticed that the edge of the blade away from me is almost 1/8" closer to the fence than the front edge. My fence is true to the miter slot so that is not the problem. I have taken the saw apart and, if I loosen the trunnion bolts and slide it to one side in the rear of the saw and to the other side on the front of the saw, I still can't get it to line up. Any suggestions are appreciated.