Hi,
So far I have successfully cut through and half-blind dovetails on the jig. The instructions were clear enough and after a couple of tries I had them fitting quite nicely.

On the other hand, sizing the tenon for sliding dovetails still baffles me. Am I supposed to guess at the settings? The instruction manual is unclear. Can any PC 4212 or 4210 users please give me a few pointers?

Here is a link to the basic manual. Go to page 23 -24 for sliding dovetails. http://www.deltaportercable.com/jigs...lJigManual.pdf

Thanks,

Brian