I have scoured the router bits on the Internet for a few days and i cannot find a bit that makes a long (about 1.5") shallow convex profile. The bits that I have found are too short about 3/4" convex profile and they also create a flat edge at each side of the profile which i don't want. Should I be looking elsewhere other than at router bits.
It might help to explain what I want to do, basically i want to cut a convex profile into rail and stiles, and then on each side of the convex profile there would be a simple beaded edge or something not sure yet.
The closest bit I found was actually provided to me by someone else in this forum for another project I have, it is close and will give you an idea as to what i am looking for I just don't want the decorative edge that comes with it.
http://www.sommerfeldtools.com/item....1010&d=102&b=1
Someone else mentioned a crown molding bit but again those all come with more decorative edging than I want. unless you can remove part of the crown molding bit?
Just curios if there was a bit or another method for doing this
Thank you