I have a hybrid TS but, since the trunnions attached to the saw top, it is more like a contractor saw in that respect.
I purchased PALS and installed them with no problem.
However, the "hole" in the PAL is actually a "hole" that fits over the bolt rather than a "slot".
I would expect there to be a slot (or at least a hole that is much larger than the bolt) so there is room for the trunnion to move.
The problem is that as I adjust the PAL expecting the trunnion to move to the side there's no room to move since the PAL has a "hole" and no "slot".
All I believe I'm doing is bending the PAL since it cannot move the trunnion.
I hope this description makes sense.
Jeff