What is the best way to set-up and cut box joints when there is a 10 degree angle on the ends of the pices you are trying to joint?
What is the best way to set-up and cut box joints when there is a 10 degree angle on the ends of the pices you are trying to joint?
You mean something like this?
Not the only way, but what I did was cut the joint first, then bevel the fingers...there's a diagram in that thread that shows the process.
(If you mean something where the corner is square but the sides lean in, I have absolutely no idea.)
Last edited by Lee DeRaud; 03-28-2008 at 10:35 AM.
Yoga class makes me feel like a total stud, mostly because I'm about as flexible as a 2x4.
"Design"? Possibly. "Intelligent"? Sure doesn't look like it from this angle.
We used to be hunter gatherers. Now we're shopper borrowers.
The three most important words in the English language: "Front Towards Enemy".
The world makes a lot more sense when you remember that Butthead was the smart one.
You can never be too rich, too thin, or have too much ammo.