Critique Requested

[robert hainstock]

You might try , (if you want too) satin rub on poly. And to fill the pores in any open grained wood Apply a coat or two, and remove it, (sand it down) with one of those green scrubby pads from the grocery store. This process gradially fills the pores and leaves a smooth surface. Still a beautiful piece!
Bob

[Jim Maxwell]

I like it. A nicely balanced piece, well finished.
Jim

[Allen Neighbors]

You are to be commended for the expertise with which you have turned this piece. It is exceptional, for a turner who has only been at it for 8 months!
But then, of course, just to detract a little from the kudos... you've been fortunate enough to have received instruction from Wally? How lucky can you get!?!?!?! (Not to detract from your Pop's basics, at all, nor his gift.) You are indeed a fortunate man.
Great job!!
Now, to get in touch with Wally...... hmmmm.....

[Joe D'Attilio]

Critique I can not, but that is absolutely stunning - I only hope I can turn something 1/2 the caliber of yours in 8 months!

[Glenn Hodges]

Ken, you are to be commended at picking Ray to copy. We all start out copying what others have done, and you chose a challenging piece. The good thing about you is you gave him credit. The piece speaks for itself and your ability. I can't give you credit for the design only because it belongs to Ray, but appreciate your expertise in choice of woods, workmanship, and finish. Thanks for letting us view such a beautiful piece, and I look forward to viewing more of your work.

[curtis rosche]

thats amazing

[John Shuk]

Ken,
The base especially pulls off the oriental influence very well. It is a nice piece and you should be proud of it.

[Ken Vonk]

Thanks everyone for the kind words. I can see a 1/4" or so straight spot on the side I also had trouble getting the lid to fit the angle of the top of the 'box'. What would you guys use? A skew chisel? A thin parting tool? I had to cut back at an angle while still mounted on a waiste block and ended up with a little chamfer where the lid transitioned to the part that sticks down into the box. Make sense...lol

Thanks again,

Ken