I don't know if this belongs in this forum or someplace else, but I figure it's all about finish spraying so here goes:
I just bought a spray gun, looks good, works fine. The problem is I moved my compressor out of my air conditioned, humidity controlled shop, into a non-environmentally controlled room. Now I'm picking up water in the air line. I haven't done enough spraying to see a problem but I know it will cause problems with water in the finish. So my question is "What should I install to get rid of the water, condensate trap, desiccant drier, oil and water filter? Or should I just move it back into the main shop?"