Hi all! I'm hoping someone has a solution for my current problem, which is making me blue in the face, not to mention wasting quite a bit of time and acrylic.
After engraving a few of these small gear logo's, and removing the acrylic to spray/colorfill, i can't get the material lined up back in the exact same spot in order to vector cut. I'm using a standard sheet of 12x24 acrylic and, to the best of my ability, try to get the sheet back as perfectly in the upper left corner as I can.
Some are harder to notice (gear on left) while others are incredibly obvious (gear on right)
Is there any way to set a home position, or something of that sort with the X/Y axis on the laser to match where the gear shapes are in Corel?
(I have not moved any of the shapes on my Corel file from the same place they were engraved)
Any help would be MUCH appreciated. Thanks
[Running this job on an Epilog Mini 40]
gears.jpg