Good morning everyone! I've got a few questions that I can't seem to find answers for. I'll post each under a separate topic.
I have the following mock plaque which is made up entirely of vectors. Sending this to the laser from corel x7 via rdworks v8 and using "scan" (engrave) for both layers (or just one layer - I understand using two takes significantly more time when both are being scanned) produces the results I'm looking for but drawing the border is slowing things down. Even if everything is on the same layer. It could go faster if I use "cut" for the border layer but that apparently limits me to thin "cut" lines and not the wider, filled border that I want. I'm aware I could defocus the lens by dropping the table a bit or perhaps redesign and use several thin lines for the border, but I was hoping for a solution that would ultimately cut down on the time to produce each plaque. Ideas?
CorelMockPlaque.jpg