Do you have any other tools running on 240 volts currently? Just to confirm that you have two separate phases. It sounds like you do if you measured...
We have one. In fact I just used it to call our cell provider tech support. Cell service is miserable here. Neighbors with house phones by cable lose...
I agree with Andrew for the reasons he stated...with the small machine for scrolling and detail work, go for the larger wheel and power machine when...
Measure the distance between the centers of the drive and idler pulleys and add half the circumference of each pulley. Otherwise, wrap a cord or flat...
For the size of this shop for distances and drops, I strongly suspect that the current DC is potentially inadequate as the 6" inlet absolutely limits...
A compression bit will work, but they are generally designed for situations where one needs to have pristine cut lines on both top and bottom. There...
No personal experience or knowledge of it. I did a search and on router forums (old thread) it was discussed and generally seemed to be well thought...
1) Accurate polling is a very difficult and expensive proposition. The primary issue is ensuring that the sample is representative, as many have said...