Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 12:56 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Ronald Blue Today, 9:43 AMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: stephen thomas Yesterday, 1:46 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Ronald Blue Today, 8:39 AMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Rod Sheridan Yesterday, 8:29 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Mike, I just replied to your private message.
The Domino has been sold and shipped to Mr. Dymond.
I agree the analysis of the data is basic math statistics, the black magic part is the selection of the survey group and the framing of the question.
Doug Garson Today, 12:46 PMRe:lapping an arkansas stone prior to each use.
Even a "Soft" arkansas is quite hard and wears very slowly. Under normal use,
Laguna still sells a line of Italian-made bandsaws. The BX series saws are made in Taiwan. The 14 SUV was made in China by Harvey, but was discontinued
Geoff Crimmins Today, 12:33 PMI don't use many metal fasteners anymore but I agree with your furniture builder comment.
I have both 12v and 18v tools. The 12v are plenty strong
Dining room carver chairs - Take 2
Thread Starter: Derek CohenAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 6:12 AM