Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 4:08 PMThere is a person, that has designed very crazy looking squirrel houses. All kinds of fancy, moving parts, and such. He sells the plans to make these squirrel houses in print form, as pdf, and as dxf. He does not sell kits, nor parts. Plans only. Oh his policy page, he writes the following: ...
Last Post By: Edward Weber Today, 11:13 AMI'm looking to build my first set of cabinets in my kitchen. I'm currently building a new house. I am a third generation general contractor so l have a good degree of knowledge in construction my grandfather used to build furniture and cabinets so I have a very good general idea of how they need to...
Last Post By: George Yetka Yesterday, 3:26 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Maurice Mcmurry Today, 10:19 AMHello Everyone, I am new to this forum and was directed here by Joe at Veneer Supplies. My question is in regard to veneering over compound curved shapes, mainly guitar bodies. I am a boutique guitar builder and I am concerned with the longjevity of the flamed and quilted maple supplies as...
Last Post By: Maurice Mcmurry Yesterday, 12:39 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Beautiful work as always Stan
Edward Weber Today, 11:18 AMI fully agree, there just seems to be more murky area than clear, concise definition. There also seems to be a "it depends" added to everything.
Edward Weber Today, 11:13 AMDon't see these often, but I have a set of wings, brackets, etc. Wings are 74" long each. Comes with older Hitachi 10" miter saw with Diablo
gary wallen Today, 11:11 AMI understand what you are saying , when I first got my cnc I really went into 3d machining , but its takes a lot of time
and money wise its not
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 6:14 PM