Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Stan Calow Today, 9:00 PMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Today, 4:35 PMWifey said I have to wait until tomorrow before opening the Shaper Origin but I tricked her into allowing me to open the workstation early :) Got the workstation mounted on my Husky toolbox with a raising table so I can do some box joints on 48" long stock, for an upcoming project. I've also...
Last Post By: Michael Burnside Today, 9:16 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Bill Dufour Today, 10:15 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
In the past i sometimes needed plywood elements that were from 9' to 12' long. Often for contour bandsaw & shaper patterns to carry curved flooring,
stephen thomas Today, 11:15 PMThese are the reasons why road rage incidents happen. I try to practice patience, but some of these bozos make me wish I was driving a tank and could
Mike Wilkins Today, 11:09 PMI ordered one of the Bosch Routers - I'll get a couple more if I like it.
Bradley Gray Today, 11:07 PMHi,
Just wondering if anyone has any Steve Knight Toolsworks planes they would like to sell. I have smoother that I really enjoy using. It’s 9”
I grew up in Western NC, Rutherford County, Forest City. Small town about an hours drive to Asheville or Charlotte, and they have a Lowes.
No woodworking
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Mike Wilkins Today, 11:09 PM