Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Stan Calow Yesterday, 9:00 PMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Yesterday, 4:35 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Michael Schuch Yesterday, 11:31 PMLooking to upgrade from my old 6" Jet JJ-6cs jointer (which I put a helical head on). I just have a hobby shop for personal use but would like to get an 8" jointer since I find the 6" too small. I've for the most part settled on Grizzly for their affordability and overall good reviews. G0490ZX:...
Last Post By: Warren Lake Yesterday, 10:23 AMAbout the only thing that will not add moisture would be (WEST) epoxy.
But regardless the glue, you are going to have to press it flat, so if left
Not sure, exactly, what this has to do with unboxing and helping a fellow creeker.
Dave Zellers Yesterday, 11:40 PMI have never seen ANY 1ph motor higher than 3hp run on 120v. To me that sounds like the problem. Every 7hp 1ph motor I have seen needs 240v. Above
Michael Schuch Yesterday, 11:31 PMI am not a fan of Craftsman routers either. I would look at a Bosch or Dewalt router instead.
Craftsman sourced their electric tools from
Holy brilliance, Batman! I recently installed some 5000k lights in my shop and was duly impressed by them. Can I get a link to these 10,000k lights?
Dave Zellers Yesterday, 11:23 PM
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Mike Wilkins Yesterday, 11:09 PM