Saw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Edwin Santos Today, 1:11 PMLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Dick Strauss Today, 8:16 AMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 10:02 AMHi all, I have a Laguna Cflux-3 that was giving me some intermittent issues turning the unit on and would take a few hits of the switch or remote control 'on' to get it to start up. Today, the motor won't start at all. I do get a 'beep' coming from the circuit board when turning it on and the...
Last Post By: Robert Hayward Yesterday, 11:00 PMHI! I am new here and new to the combination machine world... Regardless I have the opportunity to purchase a 1999 BF 631 for a ridiculously low price. It does come with some issues that I need to mentally resolve before pulling the trigger. Felder considers this an "old" machine and thus...
Last Post By: steven sivak Yesterday, 9:24 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I’ve made a couple of adapters from PVC plumbing pipe. Chuck the pipe in the lathe and reduce the size of the inside, the outside or both.
Keith Pitman Today, 2:24 PMNot understanding your issue, perhaps a picture or sketch would help.
Doug Garson Today, 2:20 PMPatrick, most of the dowel plates are just too thin. Get a piece of scrap steel that is at least an inch thick, drill holes , champher.
Mel Fulks Today, 2:08 PMSo our old microwave a GE bit the dust, was perhaps 20 years old. Purchased a new one and instructions said needs to be 13 inch deep cupboard at the most,
Bill George Today, 2:07 PMDowel Plates. I have had four, I make wonky dowels with all of them. Had to have one, tried it out with bad results. Sold it. Repeat. Repeat. Repeat,
Patrick C Daugherty Today, 2:01 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 6:38 PM