About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 11:04 AMMy friend in So. Dk. was given a fair amount of Osage Orange. He hauled home and called me to tell me how heavy it was. He said it had been in a barn for several years and was thrilled to have. The next day his back was hurting severely. He lives in a small town that has pretty good medical care....
Last Post By: Bradley Gray Today, 5:15 PMAnswer = Tape
Last Post By: Alan Rutherford Today, 9:34 AMHi folks, I'm looking for advice on whether to ignore/repair/euthanize a misaligned Dewalt 735. A couple of years ago, I bought a used Dewalt 735 from a guy who had already installed a byrd cutterhead on it. I've recently realized that it is out of parallel by ~0.013". Picture attached...
Last Post By: Sam Shankar Today, 8:47 AMWhile reviewing different approaches in preparing card scrapers I found the method used by Rob Cosman to be the most involved. Basically he recommends flattening and polishing the 3 surfaces of each side, eventually using a 16000 grit Shapton stone. He also employs the Charlesworth ruler trick to...
Last Post By: John C Cox Today, 11:06 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
^^ THIS ^^
Check the brushes but what you describe sounds like a bad capacitor on the control board.
stuff seems to dissapear all the time. Tons of shop stuff and hard to manage it all for a few reasons. Years back I took the back seat out of one of
Warren Lake Today, 6:59 PMThats good. My way is slower but it works fine. With the beams 8" wide you do the 12 foot length then do the other side and I have three beams.
Warren Lake Today, 6:02 PM2 or 3 minutes for 1" wide banding according to the website. They typically put 1/4" banding on veneer blanks and the throughput keeps one man
Kevin Jenness Today, 5:40 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 6:38 PM