My doc tells me I need an neck MRI to diagnose some arm pain that may be starting in the neck. On the phone the MRI facility asked me if I had ever been involved with "metal grinding". Of course as a woodworker I've sharpened tools on a wheel, drilled holes in metal etc. I'm hoping to get more...
Last Post By: Ken Fitzgerald Today, 1:56 PMI'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: John TenEyck Today, 9:54 AMHello, I’m looking for advice and recommendations for a good plan or kit to construct a sailboat for a novice crew. My 10yo daughter went to sailing camp last summer and had a blast. It was a skills based camp that eventually leads to racing and ASA certification. They used what appeared to...
Last Post By: andy bessette Yesterday, 7:38 PMAt least one that looks better than this? I think I can build something a little bit better than that plastic blister pack... Maybe take a plan from Paul Sellers Masterclasses, and build a case? and.. Will have to change a couple sizes...
Last Post By: steven c newman Today, 1:59 PMWell, I made the mistake of having my leaf blower repaired two years ago and it will not start this season, OH well. Note to self don't repair these things. Anybody use battery operated leaf blowers and how do you like them? Thanks. Brian
Last Post By: Lee DeRaud Today, 4:44 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
There were very few car wash/gas stations around here. As far as I know they all closed down years ago. They have been building semi do it yourself “ride
Bruce Page Today, 5:03 PMRichard, it's for an outdoor table top using cypress, miter corners would look better, but might be a bad choice. Butt joint is probably a better choice.
Brian Runau Today, 5:02 PMSteve, I'm using a sled with a hold down, still slipping you think? thanks brian
Brian Runau Today, 5:01 PMI thought sulfur rods were just pure aluminum.
We had the problem and could just detect it in the water from the well. Had a Cullligan Rustmaster
Nicholas, this thread is 15 years old. I suspect Travis has either found his workbench or given up hope and settled for something else.
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Mike King Yesterday, 6:28 PM