• Brian Kent

    There is no available content written by Brian Kent
  • Recent Polls

    best source for old tools when rust hunting (Votes: 51)

    1. Flea market (Votes: 13)

    2. antique stores (Votes: 7)

    3. antique malls (Votes: 12)

    4. garage sales (Votes: 11)

    5. auctions (Votes: 8)

    6. estate sales (Votes: 16)

    7. association meeting (Votes: 5)

    8. other (Votes: 8)

  • Recent Forum Posts

    Bill Conerly

    Router with 1/2" collet

    Thanks everyone for you advice.

    I bought a 1/2 to 1/4 reducer, which didn't fit. I had been assuming 1/2. As best I can measure, my collet

    Bill Conerly Today, 9:08 PM Go to last post
    John K Jordan

    General update and (skew) chisel question

    Ryan, the picture didn't show but I found some pictures on the Webbed Wide World. Could you measure the length and both diameters of the taper of one

    John K Jordan Today, 9:08 PM Go to last post
    Patrick Chase

    Blades and Frogs

    I'm going to go out on a limb and guess that the fact that nobody bothered to copy that design when the patent ran out (c. 1946) is telling us something.

    Patrick Chase Today, 9:05 PM Go to last post
    Jerome Stanek

    Prescription Eyeglasses

    Last Saturday I hit a deer that smashed the windshield and drivers window and my glasses took the brunt of the flying glass. They were chipped up pretty

    Jerome Stanek Today, 9:02 PM Go to last post
    Mike Chalmers

    Jointer Pulley Alignment

    Installed link belt today. Used the alignment jig as soon as the old belt was off. Pulleys actually seem to be co-planar after all. Although there

    Mike Chalmers Today, 8:49 PM Go to last post
  • Recent Blog Posts