Kenneth Moar
Contributor

Mini Statistics

Join Date: 09-23-2009

Last Activity: Today 8:09 AM

Tab Content: Kenneth Moar's Activity; About Me

Tab Content: All; Kenneth Moar; Photos

Older Activity
05-18-2024, 4:43 PM

Kenneth Moar replied to a thread Should I replane three week old edges before glue up? in General Woodworking and Power Tools

Following up on my post, I did the glue up without replaneing the pieces. I'm going to guess that three weeks of oxidation or case hardening on the...

see more

17 replies | 1729 view(s)
05-10-2024, 9:47 PM

Kenneth Moar replied to a thread Should I replane three week old edges before glue up? in General Woodworking and Power Tools

I'm gluing hard maple, no need for acetone on the edges. In the past I had a joint fail in Osage wood. should have wiped the edges with acetone...

see more

17 replies | 1729 view(s)
05-08-2024, 6:57 PM

Kenneth Moar started a thread Should I replane three week old edges before glue up? in General Woodworking and Power Tools

I got delayed doing a bench top glue up by about three weeks, now I'm wondering if I should replane everything to get a fresh edge before glue up. I...

see more

17 replies | 1729 view(s)
05-02-2024, 9:46 AM

Kenneth Moar replied to a thread 8 1/4" vs. 10" Worm Drive Portable Table Saw? in General Woodworking and Power Tools

One thing to consider is which saw will accept a full dado stack. I know the 10 inch saw will accept a full dado stack, not sure about the 8 1/4

see more

6 replies | 620 view(s)

No More Results

Statistics

Total Posts

Total Posts: 44

Posts Per Day: 0.01

General Information

Last Activity: Today 8:09 AM

Join Date: 09-23-2009

All times are GMT -4. The time now is 4:14 PM.

Powered by vBulletin® Version 4.2.5
Copyright © 2024 vBulletin Solutions Inc. All rights reserved.