• steven c newman's Avatar
    Today, 9:45 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Ok..yesterday...Had to go and bring the Boss home...(LONG story) THEN go out and pay the monthly bills, and Grocery shop....Then a trip across the...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    Today, 9:32 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Ok..got all 18 runners done.. However, came time to cut the pine back rails.. There was only enough GOOD 1x 2 left for 1 back rail....Trip to...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    Today, 9:22 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Set the router table aside, for now...cut 18 drawer runners on the tablesaw for length.. Here is about half of them....each need a tenon on each...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    Today, 9:15 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Ok, dovetail bit was done..time to change bits.. There was a time, long ago, where a router by B&D was all metal, and was a clone of a DeWalt No....
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    Today, 9:04 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    1st Router table use...needed a jig to slide along the fence.. To run parts past a dovetail bit.. 9 "rails", dovetail "Tails" on each...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    Yesterday, 9:57 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Will do an "Up-Date" later this evening..once we get the Boss back home and settled in... Warning: Router Table will be in use Warning: Tablesaw...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    Yesterday, 9:47 AM
    steven c newman replied to a thread Big chisel contest in Neanderthal Haven
    Thinking the term does or does not include slicks? And maybe not from the realm of Timber Framers? Shorty is 11" long..and a mere 1-1/2"...
    see more
    12 replies | 745 view(s)
  • steven c newman's Avatar
    05-13-2024, 9:54 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    ok, to get the rebates milled.. Had to move these out of the way...cauls were a might too close to my arms as they were going by.. Used the...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-13-2024, 9:40 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Curved areas near the feet, used a drum sander in a cordless drill...high rail was lower,,,with a beltsander, and couple spokeshaves..and a palm...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-13-2024, 9:27 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Up date time...the 2 sides were clamped together, inside to inside...the back stiles already have their rebates milled to house the 1/4" plywood...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-12-2024, 11:58 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Had to replace a curvy one.. Had enough "Leftovers" for that.. The wide one on the bottom..isn't quite that wide, any more The best 9 rails...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-12-2024, 11:50 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    These 2 planks.. Needed to be cross cut in 24" (Roughly) lengths Then run through the rip fence at 1-3/8" width... Then needed to skinny...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-12-2024, 11:37 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Side #2 is out of the clamps.. And Standing in front of Side #1...back to back...one foot will need trimmed a bit, otherwise, they match up quite...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-11-2024, 5:15 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    2 hours and 20 minutes in the shop, today...Results? Well..there is the inside of Side #2...being glued up.. Had to get 8 raised panels and 9...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-11-2024, 10:49 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Shopping trip..$108.86 Need to load this up.. Into this space.. Needed to fold the other back seat down..so the 8' long 1 x 4s will...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-10-2024, 6:57 PM
    steven c newman replied to a thread 2 items from a Road Trip in Neanderthal Haven
    Well..I did try to get $20 off....but..he only allowed the 10% the Mall gives...on anything over $40... Cheer Up....Yard Sale Season has started...
    see more
    10 replies | 1594 view(s)
  • steven c newman's Avatar
    05-10-2024, 6:54 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    The Boss is coming home next Wednesday Afternoon-ish...Same day as Pay Day...I get to go out, and pay the bills that morning, then go pick her up. ...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-10-2024, 6:29 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    A dry fit that also involved a panel... Did not go well...seems I will be doing this, tomorrow...again.. The Dreaded Too Fat Rebate....back has...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-10-2024, 6:25 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    2 stiles also got their feet sawn... Was a good thing that this was the "inside" for both Stiles.. As both had a few "bad" spots, all on one...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-10-2024, 6:22 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Dry fits..first one of the day.. And the Last Dry fitted rail of the day.. 18 Mortises were chopped and fitted to the rails, today...tool? ...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-10-2024, 6:19 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Well, that glue-up is now out of the clamps, and standing up on it's own 2 feet.. Next 2 Stiles look like this.. 2 hours IN the shop,...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-09-2024, 8:28 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Set one stile on the bench and into the jig....it was marked for "INside" so set that face away from me...then glue on tenon, and a spot of glue in...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-09-2024, 8:14 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Rails needed to look spiffy, of course..all 9 of them..first task was deciding which face looked the best.. And which didn't quite make the...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-09-2024, 8:10 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Hmm, try again on photos..This morning worked on getting Raised Panels ready.. from this.. Saw marks, burnt spots, ridges. and rough stuff..to ...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-09-2024, 10:11 AM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Plan last night, was to haul a stack of supplies to the shop, and bring a hamper of dried clothes back upstairs... Plan got changed a bit..set all...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-08-2024, 9:43 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Hauled a stack of supplies to the shop, tonight....decided to fix the two wide rails...then went ahead on chopped the 9 mortises in the matching...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-08-2024, 5:15 PM
    steven c newman replied to a thread Miller Falls 17B Block Plane Help in Neanderthal Haven
    The "G" was for Government Contracts (WW2)..The "B" merely meant an Improvement was made..of some sort..either an upgrade, or to make a tool easier...
    see more
    4 replies | 516 view(s)
  • steven c newman's Avatar
    05-08-2024, 12:35 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Maybe later today? Move things around, and chop the 9 mortises in Stile #3...to match Stile #4's 9...and prep things for a glue up? Then, while...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-08-2024, 12:32 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    So far, so good.. Before the Raised Panels could be Dry Fitted up..needed to work on the face that will show, a bit. . Removed any saw/burn...
    see more
    49 replies | 3435 view(s)
  • steven c newman's Avatar
    05-08-2024, 12:28 PM
    steven c newman replied to a thread Lumber supply in Neanderthal Haven
    Ok..back to doing "Spoon feed" for the photos..and see IF things are any better... Had FAT Rebates.. We have ways.. Run the Craftsman No. 3720...
    see more
    49 replies | 3435 view(s)
More Activity
About Troy Turner

Basic Information

About Troy Turner
Biography:
Started woodworking about 2001. Needed a shelf to go over a window so I went shopping. Yeah, they had one, for $30 unfinished. It just happened to be on the same aisle as the wood. That amount of wood only cost about $5. Well, $5 worth of wood and about $400 worth of tools, and boom, a window shelf. What makes each of my projects unique, is because I know exactly what's wrong with them :)
Location:
Tyler, TX

Statistics


Total Posts
Total Posts
553
Posts Per Day
0.11
General Information
Last Activity
02-21-2022 10:35 PM
Join Date
01-11-2010

1 Friend

  1. steven c newman steven c newman is offline

    Contributor

    steven c newman
Showing Friends 1 to 1 of 1